CONTROL ONE — BENCH TEST MODE

Prove the control path before touching real RF output.

This page reads your saved TX16S mapping, applies the Apex safety gate, and sends validated commands to the Windows Apex Local Bridge. Bridge v0.2 can verify the first ESP32 servo adapter and automatically switch from simulation to hardware mode.

INPUT DEVICE

No controller detected

Mapping incomplete or missing

LOCAL HARDWARE BRIDGE

Not connected

Local bridge has not been checked yet.

Set Up Physical Adapter

SAFETY GATE

Servo-only test fixture or safely restrained vehicle; no propeller and no exposed drivetrain Neutral position verified before output Disconnect/failsafe event observed

VIRTUAL SERVO / LOCAL BRIDGE COMMAND

Steering / Roll → 90.0°

Mapped input: not found · live value 0.000

OUTPUT LOCKED

Back to Control Bridge

BENCH TEST RESULT

⬜ Saved 7-control mapping loaded

⬜ TX16S USB input live

⬜ Safe bench fixture confirmed

⬜ Neutral verified

⬜ Failsafe/disconnect observed

⬜ Windows Apex Local Bridge connected

⬜ Physical hardware adapter connected and verified

Open Hardware Adapter Setup